K26S 26 inch Kalamazoo Industries industrial abrasive chop saw replacement parts.
-
044-008 trunnion pillow block bearing is for the 26 inch chop saws with 20HP 3PH motors. This industrial bearing has a grease point which will extend it life. -
044-009 INDUSTRIAL CHOP SAW SPINDLE BEARING SET
044-009 industrial chop saw spindle bearing set are sealed bearings with dual set screws to lock the spindle into place. -
044-033 industrial oscillation pillow block bearing is used on the K20E 20 inch and K26S and K26W 26 inch industrial saws with that have oscillation. -
049-011 spindle pulley bushing is for the industrial K20FS 20 inch foundry chop saw and the K26S 26 inch dry abrasive cutoff saw. -
049-012 motor pulley bushing is for the industrial K20FS 20 inch foundry chop saw and the K26S 26 inch dry abrasive cutoff saws. -
051-008 timing belt is for the K26S dry and K26W wet 20HP 3PH industrial abrasive chop saws. -
053-016 26 inch abrasive cutoff saw cam vise block. This cam vise block was designed to be used on the K26S dry abrasive chop saw. -
1-34-65 POWER DOWN FEED CYLINDER SWIVEL BRACKET
1-34-65 power down feed cylinder swivel bracket connects the cylinder to the cutoff saw frame. This swivel bracket comes with pin and e-clips. -
131-009KIT is the air over oil power down feed cylinder repair kit for 131-009 cylinder that's used on the 26 inch and 30 inch cutoff saws. -
146-006 26 inch abrasive cutoff saw cam vise t-nut. This t-nut is used to clamp and lock the CV-26 cam vise on the K26S chop saw. -
294-017 flow control valve for air/oil power down feed system for the 26 inch abrasive chop saws and larger. Inlet/Outlet port sizes 1/2" NPT Hydraulic flow control valve -
537-028 abrasive chop saw spindle nut is for the K26S dry and K26W wet 26 inch 20HP 3PH industrial abrasive chop saws.